Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- projekte:3cmcompacttrv:start [2022/05/23 18:11] – thasti
+++ projekte:3cmcompacttrv:start [2022/05/23 18:12] (aktuell) – [Transverter PCB] thasti
@@ Zeile 27: / Zeile 27: @@
 {{:projekte:3cmcompacttrv:tx_bb_filter.jpg?400|}}
+=== RX IF Filter ===
+The original 70 MHz IF filter is not used and the signal path is switched to the second not populated filter footprint. A pcb with a 3rd order 50 MHz bandpass filter was made and fits on this footprint.
+{{:projekte:3cmcompacttrv:rx_if_filter.jpg?400|}}
+schematics: {{ :projekte:3cmcompacttrv:rx_if_filter_scm.pdf | RX IF filter}}\\
+project files: [[https://git.loetlabor-jena.de/yc/10g_cambridge|if_cambridge]]\\
+errata:
+  * PCB pinout is flipped vertically, hence short wires are required to connect RF path to coupling capacitors on the PCB.
 === TX IF Filter ===
@@ Zeile 40: / Zeile 50: @@
 errata:
   * MMCX instead of MCX used, fix in next revision
-=== RX IF Filter ===
-The original 70 MHz IF filter is not used and the signal path is switched to the second not populated filter footprint. A pcb with a 3rd order 50 MHz bandpass filter was made and fits on this footprint.
-{{:projekte:3cmcompacttrv:rx_if_filter.jpg?400|}}
-schematics: {{ :projekte:3cmcompacttrv:rx_if_filter_scm.pdf | RX IF filter}}\\
-project files: [[https://git.loetlabor-jena.de/yc/10g_cambridge|if_cambridge]]\\
-errata:
-  * PCB pinout is flipped vertically, hence short wires are required to connect RF path to coupling capacitors on the PCB.
 ==== RF Board ====